01-00042 Wheel bearing puller for 3 – 4 bolted bearings with dismounted hubs. Suitable for VW, Audi, Seat and Skoda

The bolted bearings can be rusted and stuck in the aluminum or steel knuckle. In many cases the old hub needs to be used also in the new bearing and has to be dismounted.
The tool is developed for time saving job directly on the car, in most cases also with the axle shaft still in the hub. The hub/bearing tool 01-00040 is used (not included) when dismounting the hub.
With the bolts from the old bearing and the four washers in the set the fixture plate is mounted on to the bearing. Dismounting tool 01-00026 (4 bolt) or
01-00027 (3-4 bolt) is used as a press fixture when pressing out the stuck bearing. The job is made with one of our cylinders from 18 – 22 ton (max pressure 18 ton).
The Sliding hammer 1064 can also be used as a manual solution with carriage beam RES4029.

Parts in set:
1. 01-00042-001 Bearing puller plate
2. 4 x 01-00042-002  Adjustment washer
3. 01-00042-003 Carriage beam M22, 65 mm